Disconnect the ribbon and power cables fromħ Remove the four screws that mount the Zip drive to the carrier and slide the drive out of the carrier. If shielding tape connects the ribbon cable and the carrier, detach the tape from the top of the carrier. Disconnect the ribbon and power cables from the back of the CD/DVD drive. Remove the two screws that secure the drive carrier. Note: You will feel some resistance as you push on the carrier. Swing thĢ Remove the two screws that hold the drive carrier in place and push the carrier forward far enough that you can reach the cables behind it. Removing the Installed Zip Drive 1 Press the clips behind the drive faceplate assembly, rotate the assembly forward until the clips are free of the front panel, and carefully continue rotating the assembly forward to remove it. Gently lower the side panel until it lies flat. Close the side access panel and shut down the computer before proceeding. Warning: If you see any lights glowing on the main logic board, the computer has not been shut down. 4 If you attached a security cable through the computer’s loc Then wait five minutes for the computer’s internal components to cool down. 3 Shut down your computer by opening the Special menu and choosing Shut Down. 2 If you think your computer is in sleep, press the power button on the front of the computer to wake it. 1 Place your computer on a clean, flat surface. Opening the Computer Warning: Always turn off your computer before opening it to avoid damaging its internal components. Note: Written and video instructions covering customer-i Replacing the Zip drive requires five basic steps: Failure to follow these instructions could result in damage to your equipment and may void your warranty.
K Power Mac G4 / Macintosh Server G4 Zip Drive Replacement Instructions Be sure to follow the instructions in this sheet carefully.
0 kommentar(er)
